# Wipforth

## Building and Running

To run, first compile the WebAssembly module:

```
wat2wasm --enable-threads wipforth.wat
```

Then run the server:

```
python3 server.py
```

You should then be able to open <http://localhost:8080> in a browser
and use the system from there.

**NOTE**: The server is just a very simple instantiation of Python's
built-in `http.server.HTTPServer`, configured to set the cross-origin
headers required for `SharedMemoryBuffer` use.  You could use any HTTP
server that sets these headers.

## Peripherals

# Terminal

| Name   | Offset | Size / B | Access       |
|--------|--------|----------|--------------|
| TXBUF  | 0      | 32       | write        |
| RXBUF  | 32     | 32       | read         |
| TXHEAD | 64     | 1        | atomic read  |
| TXTAIL | 65     | 1        | atomic write |
| RXHEAD | 66     | 1        | atomic write |
| RXTAIL | 67     | 1        | atomic read  |

For both sending (`TX`) and receiving (`RX`), there are three
registers: `xBUF`, `xHEAD` and `xTAIL`:

- `xBUF` registers are 32-byte FIFO ring buffers used for data
- The `xHEAD` and `xTAIL` registers specify the start and end of data
  in the ring buffer, `xHEAD` being the offset of the first byte of
  data, and `xTAIL` being the offset of the first byte *after* the data.

In order to be distinguishable from the empty state, the ring buffers
must never be completely full -- there must always be *at least one*
unoccupied byte between the tail and the head.

# System status

| Name     | Offset | Size / B | Access       |
|----------|--------|----------|--------------|
| SYSREADY | 68     | 1        | atomic write |

The `SYSREADY` register is used to indicate when the system has booted
up and is ready for user input.